Arduino UNO – Jingle Bells & LED Synchronization

Now Reading
Arduino UNO – Jingle Bells & LED Synchronization



Portfolium: https://portfolium.com/entry/arduino-jingle-bells-synchronized-lights
This Arduino project uses:
1x Arduino UNO
1x Small Bread Board
1x Piezo buzzer
8x Wires
4x 330 Ohm resistors
1x Red LED
1x RGB LED (dead red diode)

NOTE: The RGB LED’s red diode burned out so I used a Red LED with the same function. At the time a spare RGB LED was not available.

Jingle Bells music was coded from the music sheet found here:
http://pianoandsynth.com/jingle-bells-piano/

Frequencies used on the Arduino are found here:
http://www.seventhstring.com/resources/notefrequencies.html

source

Comments

comments

What's your reaction?
Love It
0%
Like It
0%
Want It
0%
Had It
0%
Hated It
0%
About The Author
admin